ObsidianWire Custom 4-Way for Tele

84.00

MAKE YOUR TELE SCREAM.

The ObsidianWire Custom 4-Way wiring harness adds a fourth position to your Telecaster for a new dimension of sound. The bridge and neck pickup work together for a humbucker like tone, which is usefull for both rhythm and lead playing. While the Custom 4-Way gives you a 4th position option, the traditional switch positions remain along with the classic master tone and volume controls.

ObsidianWire’s Custom 4-Way wiring is an easy to install, pop-in upgrade for your Telecaster. Using their revolutionary approach to guitar electronics, this pre-wired harness is a completely solderless solution with special lock-down “Plug, Play & Enjoy” connectors – simply twist your pickup’s wire and insert them into the connector slots and you’re done!

The ObsidianWire Custom 4-Way also includes an ObsidianWire Custom Spec Treble Bleed Mod, which helps to eliminate “muddiness” at lower volumes by allowing high frequencies to pass along a separate path to your amp. Without the Custom Spec Treble Bleed Mod, the frequencies would be stopped short by the increasing resistance at the volume control, leaving you with an unclear tone.

CLICK HERE FOR INSTALLATION INSTRUCTIONS

Out of stock

Description

MAKE YOUR TELE SCREAM.

The ObsidianWire Custom 4-Way wiring harness adds a fourth position to your Telecaster for a new dimension of sound. The bridge and neck pickup work together for a humbucker like tone, which is usefull for both rhythm and lead playing. While the Custom 4-Way gives you a 4th position option, the traditional switch positions remain along with the classic master tone and volume controls.

ObsidianWire’s Custom 4-Way wiring is an easy to install, pop-in upgrade for your Telecaster. Using their revolutionary approach to guitar electronics, this pre-wired harness is a completely solderless solution with special lock-down “Plug, Play & Enjoy” connectors – simply twist your pickup’s wire and insert them into the connector slots and you’re
done!

The ObsidianWire Custom 4-Way also includes an ObsidianWire Custom Spec Treble Bleed Mod, which helps to eliminate “muddiness” at lower volumes by allowing high frequencies to pass along a separate path to your amp. Without the Custom Spec Treble Bleed Mod, the frequencies would be stopped short by the increasing resistance at the volume control, leaving you with an unclear tone.

The 4-Way Telecaster Switch works like this:

1. Neck & Bridge Pickup in Series (Humbucker Like Tone)

2. Neck Pickup Only

3. Neck & Bridge Pickup in Parallel (Traditional Tele Tone)

4. Bridge Pickup Only

 

COMPONENTS:

– ObsidianWire Custom Select Pots (Crafted by CTS) (+/-8%) (Matched to +/-2%) SOLID SHAFT

– Genuine Oak Grigsby Switch

– Genuine Switchcraft Output Jack

– ObsidianWire Custom Select 150 Series Polyester Film Capacitor (Hand Tested to +/-10%)

– ObsidianWire Premium Selected Volume Mod / Treble Bleed – Improved Volume Taper & Clarity

– Easy to Follow Install Manual

 

COMPATIBILITY:

American and Mexican series Fender® Telecasters – Direct Fit

Japanese Fender & Squier – You will need to purchase a genuine Fender USA control plate and new 1/4″ knobs to fit the higher grade electronics.

Other Guitars – It is not guaranteed that these will fit any other guitar.

Note: Aftermarket control plates will not fit – a genuine Fender control plate is recommended (Part Number: 099-2058-000)

ObsidianWire uses US spec 1/4″ Solid shaft controls. It is recommended that you check your knobs are the correct size and replace them if necessary.

CLICK HERE FOR INSTALLATION INSTRUCTIONS

Reviews

There are no reviews yet.

Be the first to review “ObsidianWire Custom 4-Way for Tele”